Spring Checklist Inboards and Stern Drives

Spring Checklist Inboards and Stern Drives

Name
MM slash DD slash YYYY
MM slash DD slash YYYY

Commission Boat Systems

Before Launch
Load Test & Reinstall Battery
Replace Exterior Zincs
Clean/Paint Transducers
Bow Thruster: Zincs/Fluid/ Operation
Tighten Prop Nuts & Change Cotter Pin
Install Drain Plugs
Remove Mildew Bags & Buckets
Trim Tabs: Operational & Fluid Level
Check Underwater Lighting
Seacocks Operational
Clean Sea Water External lntake Strainers
All Hoses & Thru Hull Fittings Connected

Commission Boat Systems

Check Bilge Pump/Float Switch Operation
Clean Internal Sea Strainers
Clean Air Conditioner Air Filters
Shower Sumps Operational
Hot Water Heater Operation
Clean Shower Sumps
Reconnect Domestic Water System Hoses
Clean/Replace Fresh Water Strainer/Filter
Dockside Water Operation
Reconnect All Washdown Hoses
Heads Operational
Change Holding Tank Vent Filter
Macerators: Head/Fish Box/Baitwell
Y-Valves Operation & Position
Inspect Bilge Blower Hoses
Bilge Blowers Operational
Shore Power Operational
Battery Charger Operational
Steering Connections
Hydraulic Steering System Fluid level
icemakers Operational
Washer/Dryer Operational
Refrigerator Clean & Operational
Anchor Winch Operation & Lube
Inspect Fuel Fill & Vent Hose
Navigation Lights Operational
Interior & Exterior Lighting Operational
Bilge Lighting Operational
Power to Electronics:
(Navigation, VHF, Stereo, etc.)
Horn Operational
Wipers Operational & Inspect Blades
Windshield Washer Operational & Fluid

Commission Sterndrive

Inspect & Grease Gimbal Bearing
Alignment & Reinstall Sterndrive
Sterndrive Gear Oil Level
Clean Intake Screen
Grease/ Lube Zerk Fittings
Trim/ Tilt Operational/ Fluid Level
Speedometer Pickup
Trim Limit/ Position & Indicator Gauge
Drive Unit Fasteners Torque
Power Trim Cylinders Fasteners Torque
Power Steering Fluid Level
Power Steering Fluid Level
Clean & Refill Oil Reservoir Bottle

Commission Engines (Before Launch)

Seacocks Operational & Open
All Hoses Reinstalled
Reconnect Throttle Cable
Control Cables Operational
Check All Fluids/Lubes/Coolant Levels
Replace Pencil Zincs
Clean Heat Exchangers
Heat Exchanger Radiator Cap
Run Engine, Clear Fogging Oil, & Check Raw Water Pump Operation
Clean & Refill Coolant Over Flow Bottles
Motor Mounts Tight
Audio Warning System Operational
Check Engine With Scan Tool

Tune Up Engine / Generator

Select One
Replace Fuel Filters
Replace Spark Plugs
Replace Spark Plug Wire Set
Replace Distributor Cap/ Rotor
Check/Adjust Ignition Timing
Choke Operational
Check/Adjust Carburetor Idle Mixture
Throttle Open & Close Completely
Replace PCV Valve
Replace IAC Muffler
Clean Air Filters/ Flame Arrestor
Replace/ Adjust Belts
Clean Intake Sea Strainers
Replace Pencil Zincs
Install New Oil Zorb Pads

Additional Checks

Engine Gauge
Select measurement type and input in the appropriate field. Use the + to add more measurements.
Select
Port Engine
Starboard Engine
 
Shop Tool
Select measurement type and input in the appropriate field. Use the + to add more measurements.
Select
Port Engine
Starboard Engine
 
During Sea Trial
After Sea Trial
Make sure to include your name and date with any notes if you modify this form
Name Date Notes Actions