Spring Checklist Outboards

Name
MM slash DD slash YYYY
MM slash DD slash YYYY

Commission Boat Systems

Before Launch
Load Test & Reinstall Battery
Replace Exterior Zincs
Clean/Paint Transducers
Bow Thruster: Zincs/Fluid/ Operation
Tighten Prop Nuts & Change Cotter Pin
Install Drain Plugs
Remove Mildew Bags & Buckets
Trim Tabs: Operational & Fluid Level
Check Underwater Lighting
Seacocks Operational
Clean Sea Water External lntake Strainers
All Hoses & Thru Hull Fittings Connected

Commission Boat Systems

Check Bilge Pump/Float Switch Operation
Clean Internal Sea Strainers
Clean Air Conditioner Air Filters
Shower Sumps Operational
Clean Shower Sumps
Reconnect Domestic Water System Hoses
Clean/Replace Fresh Water Strainer/Filter
Hot Water Heater Operation
Dockside Water Operation
Reconnect All Washdown Hoses
Heads/ Porta-Poti Operational
Change Holding Tank Vent Filter
Treat Head System With Head Chemical
Macerators: Head/Fish Box/Baitwell
Y-Valves Operation & Position
Bilge Blowers Operational
Inspect Bilge Blower Hoses
Shore Power Operational
Battery Charger Operational
Steering Connections
Hydraulic Steering System Fluid level
Icemakers Operational
Washer/Dryer Operational
Refrigerator Clean & Operational
Anchor Winch Operation & Lube
Inspect Fuel Fill & Vent Hose
Navigation Lights Operational
Interior & Exterior Lighting Operational
Bilge Lighting Operational
Power to Electronics:
(Navigation, VHF, Stereo, etc.)
Horn Operational
Wipers Operational & Inspect Blades
Windshield Washer Operational & Fluid

Tune up Engine

Top Off Remote Oil Tank( Two Stroke Only)
Check Engine Oil Level (Four Stroke Only)
Replace Fuel Filters
Replace Spark Plugs
Replace Spark Plug Wire Set
De-Carbonize Cylinders With Power Tune
Check/Adjust Ignition Timing
Choke Operational
Check/Adjust Carburetor Idle Mixture
Throttle Plates Open & Close Completely
Trim & Tilt Operational/ Fluid Level
Check Lower Unit Gear Lube Level
Check Shift Operation F/N/R
Replace/ Adjust Belts
Engine Gauges Operational
Replace All Engine Zincs
Clean Intake Screens
Grease All Zerk Fittings
Check Engine With Scan Tool

Additional Engine Services

Service Raw Water Pump
Replace Thermostats
Replace Shift Shaft Seal (Evinrude Only)
Change Engine Oil & Filter
Empty, Clean, & Refill Remote Oil Tank

Sea Trial

** Any Operation of the vessel before a sea trial Is conducted ls at the Owners Risk **
Engine Gauge
Select measurement type and input in the appropriate field. Use the + to add more measurements.
Select
Port Engine
Center Engine
Starboard Engine
 
Shop Tool
Select measurement type and input in the appropriate field. Use the + to add more measurements.
Select
Port Engine
Center Engine
Starboard Engine
 
During Sea Trial
After Sea Trial
Make sure to include your name and date with any notes if you modify this form
Name Date Hours Notes Actions